openMemristorPDK Guide
Guide · Section 1 · Introduction to FOSS · Part 5 · about 5 min · 7 steps

openPDKcreator's Tools tab

One tab in openPDKcreator checks every program on the other pages: is it there, which version, how to install it. It can also start them. You only ever need to click whatever is inside the red box, or type exactly what is in a black box.

Do Install from scratch first, and start with openPDKcreator open (steps 1–5 of Your first simulation).

click here Click any screenshot to see it full size Keys in the player: ← → Space Esc
Hands on · about 5 minutes

Let openPDKcreator check the programs

openPDKcreator can check all these programs for you: which ones are installed, which version, where, and how to install the missing ones. It can also start any of them.

1

Open Settings

Click the Settings tab at the top of openPDKcreator.

2

Open the Tools tab

Click Tools, the second tab under Settings.

3

Read the summary

Wait a few seconds while it checks every program, then read the line at the top.

What you see16/16 tool(s) found: inside the container every program is there. Below, one row per program: its short name (Id), its job (Category), whether a PDK flow needs it (Required), Status, the Version it reported and the Path of the program file. OpenLane says superseded by librelane: LibreLane replaced it, so it isn't needed.
4

Click a program

Click the ngspice row (1). Its card appears on the right (2).

The cardWhat the program is for, which part of a PDK it works with, where it was found and its version. Then how to install it on this kind of Linux (here sudo apt install ngspice), notes worth knowing, and its website. openPDKcreator only shows install commands: it never installs anything by itself.
5

Start a program from here

Click the klayout row (1), then Launch Selected (2).

6

KLayout opens

KLayout opens, empty and ready, with our PDK's layer colours set up. Close it with its ✕.

Same set-up as the Library ManagerLaunch Selected starts each program the way the Library Manager does: KLayout with this PDK's layers, xschem with this PDK's symbols, Magic with its technology file.
7

After installing something: Recheck

If you install a program while openPDKcreator is open, click Recheck to look again.

A program says "missing"?That happens when you run openPDKcreator outside the container. Click its row, copy the install command from its card, run it in a terminal on your laptop, then click Recheck. Rows with Required: no are optional: you can work without them.